For the purpose of this Subsection, the following letter symbols shall have the meaning indicated against each:
a = projected area of bolt in main member (t' × d₃), mm²
B = width of the beam, mm
C = concentrated load, N
D = depth of beam, mm
D₁ = depth of beam at the notch, mm
D₂ = depth of notch, mm
d = dimension of least side of column, mm
d₁ = least overall width of box column, mm
d₂ = least overall dimension of core in box column, mm
d₃ = diameter of bolt, mm
df = bolt-diameter factor
e = length of the notch measured along the beam span from the inner edge of the support to the farthest edge of the notch, mm
E = modulus of elasticity in bending, N/mm²
F = load acting on a bolt at an angle to grain, N
fab = calculated bending stress in extreme fibre, N/mm ²
fac = calculated average axial compressive stress, N/mm ²
fat = calculated axial tensile stress, N / mm²
fb = permissible bending stress on the extreme fibre, N/mm ²
fc = permissible stress in axial compression, N/mm²
fcn = permissible stress in compression normal (perpendicular) to grain, N/mm ²
fcp = permissible stress in compression parallel to grain, N/mm ²
fcθ = permissible compressive stress in the direction of the line of action of the load, N/mm ²
ft = permissible stress in tension parallel to grain, N/mm ² [extreme fibre stress in bending-tension ( fb ) is safe practical estimate of tensile strength due to mode of failure in beams]
H = horizontal shear stress, N / mm²
I = moment of inertia of a section, mm⁴
K = Coefficient in deflection depending upon type and criticality of loading on beam
K₁ = modification factor for change in slope of grain
K₂ = modification factor for change in duration of loadings
K₃, K₄, K₅, K₆ = form factors
K₇ = modification factor for bearing stress
or L = span of a beam or truss, mm
M = maximum bending moment in beam, N-mm
N = total number of bolts in the joint
n = shank diameter of the nail, mm
P = load on bolt parallel to grain, N
p₁ = ratio of the thickness of the compression flange to the depth of the beam
Q = static moment of area above or below the neutral axis about neutral axis, mm³
q = constant for particular thickness of plank
q₁ = ratio of the total thickness of web or webs to the overall width of the beam
R = load on bolt perpendicular (normal) to grain, N
S = unsupported overall length of column, mm
t = nominal thickness of planks used in forming box type column, mm
t′ = thickness of main member, mm
U = constant for a particular thickness of the plank
V = vertical end reaction or shear at a section, N
W = total uniform load, N
x = distance from reaction to load, mm
y = factor determining the value of form factor K₄
δ = deflection at middle of beam, mm
θ = angle of load to grain direction
Z = section modulus of beam, mm³
λ₁ = percentage factor for t'/d₃ ratio, parallel to grain
λ₂ = percentage factor for t'/d₃ ratio, perpendicular to grain