The information contained in this section is mainly based on the following Indian Standards:
IS 1080 : 1985 Code of practice for design and construction of shallow foundations in soils (other than raft, ring and shell) (second revision)
IS 1892 : 1979 Code of practice for subsurface investigation for foundations (first revision)
IS 1904 : 1986 Code of practice for design and construction of foundations in soils: General requirements (third revision)
IS 2911 Code of practice for design and construction of pile foundations
(Part 1/Sec 1): 2010 Concrete piles, Section 1 Driven cast in-situ concrete piles (second revision)
(Part 1/Sec 2): 2010 Concrete piles, Section 2 Bored cast in-situ piles (second revision)
(Part 1/Sec 3): 2010 Concrete piles, Section 3 Driven precast concrete piles (second revision)
(Part 1/Sec 4): 2010 Concrete piles, Section 4 Precast concrete piles in prebored holes (first revision)
(Part 2): 1980 Timber piles (first revision)
(Part 3): 1980 Under-reamed piles (first revision)
IS 2950(Part 1): 1981 Code of practice for design and construction of raft foundations: Part 1 Design (second revision)
All standards, whether given herein above or cross-referred to in the main text of this Section, are subject to the revision. The parties to agreement based on this Section are encouraged to investigate the possibility of applying the most recent editions of the standards.
For the purpose of deciding whether a particular requirement of this Section is complied with, the final value, observed or calculated, expressing the result of a test or analysis, shall be rounded off in accordance with IS 2 : 1960 ‘Rules for rounding off numerical values (revised)’. The number of significant places retained in the rounded off value should be the same as that of the specified value in this Section.