3.1 For the purpose of this Section, the following letter symbols shall have the meaning indicated against each:
a = Projected area of bolt in main member (t´ × d ), mm2
B = Width of the beam, mm
C = Concentrated load, N
D = Depth of beam, mm
D = Depth of beam at the notch, mm
D = Depth of notch, mm
d = Dimension of least side of column, mm
d 1 = Least overall width of box column, mm
d 2 = Least overall dimension of core in box column, mm
d 3 = Diameter of bolt, mm
d f = Bolt-diameter factor
e = Length of the notch measured along the beam span from the inner edge of the support to the farthest edge of the notch, mm
E = Modulus of elasticity in bending, N/mm2
F = Load acting on a bolt at an angle to grain, N
f a b = Calculated bending stress in extreme fibre, N/mm2
f a c = Calculated average axial compressive stress, N/mm2
f a t = Calculated axial tensile stress, N/mm2
f b = Permissible bending stress on the extreme fibre, N/mm2
f c = Permissible stress in axial compression, N/mm2
f c n = Permissible stress in compression normal (perpendicular) to grain, N/mm2
f= Permissible stress in compression parallel to grain, N/mm2
f c = Permissible compressive stress in the direction of the line of action of the load, N/mm2
f t = Permissible stress in tension parallel to grain, N/mm2
H = Horizontal shear stress, N/mm2
I = Moment of inertia of a section, mm4
K = Coefficient in deflection depending upon type and criticality of loading on beam
K 1 = Modification factor for change in slope of grain
K 2 = Modification factor for change in duration of loadings
K = Modification factor for bearing stress
K = Constant equal to 0.584 √ 2 . 5 E f c p
L = Span of a beam or truss, mm
M = Maximum bending moment in beam, N/mm2
N = Total number of bolts in the joint
n = Shank diameter of the nail, mm
P = Load on bolt parallel to grain, N
p 1 = Ratio of the thickness of the compression flange to the depth of the beam
Q = Statical moment of area above or below the neutral axis about neutral axis, mm3
q = Constant for particular thickness of plank
q 1 = Ratio of the total thickness of web or webs to the overall width of the beam
R = Load on bolt perpendicular (normal) to grain, N
S = Unsupported overall length of column, mm
t = Nominal thickness of planks used in forming box type column, mm
t ′ = Thickness of main member, mm
U = Constant for a particular thickness of the plank
V = Vertical end reaction or shear at a section, N
W = Total uniform load, N
x = Distance from reaction to load, mm
= A factor determining the value of form factor K 4
= Deflection at middle of beam, mm
= Angle of load to grain direction
Z = Section modulus of beam, mm3
λ 1 = Percentage factor for t ′ / d 3 ratio, parallel to grain
λ 2 = Percentage factor for t ′ / d _ 3 ratio, perpendicular to grain