11. Compound wall and gates.—
11.1. Permission for construction of compound wall and gates may be sought separately or alongwith the application for permission for construction/ /building operation/development within a plot. Detailed drawings of compound wall and gates shall be submitted alongwith the application for development permission drawn to a scale of 1 cm to 1 m.
11.2. Maximum height of a compound wall along the boundary other than that abutting on a street may be permitted up to a maximum height of 1.80 mts. and along the boundary abutting on a street up to a height of 1.50 mts. only and may be of closed type up to a height of 90 cms. only. However, no compound wall shall be permitted in front of commercial establishments existing/proposed in the building, unless separate entry and exit points are provided.
11.3. Compound wall, at street junctions shall be so located, as not to disturb the minimum sight distances as prescribed in these regulations and along the intersections of streets no compound wall shall be raised to a height of more than 1.00 mts. from the crown of the road for a length of 9.0 mts. From the intersection corner of the plot, on both sides of the plot.
11.4. In case of Government/Semi Government Blocks etc., which require special security requirements, mills, factories, industrial units, storage depots and warehouses, the compound wall may be allowed to be raised to a height not exceeding 3.0 mts. from the crown of the road, provided that no obstruction to the line of sight for traffic is caused.
11.5. All gates of compound wall shall open inward only, unless the gate is recessed into the plot to a depth, which will not cause the gate to protrude beyond the compound wall line.
11.6. The entry or exit, to the plot situated at the intersection of the roads having a width of 10.00 mts. or more, shall be located at least 15.00 mts. away from the tangent point of such intersection. If the length of any side of such a plot is less
189 Inserted vide Amendment Regulations, 2023.
190 Corrected vide Corrigendum No. 21/1/TCP/2021-23/Steering Committee/157 dated 3-11-2023.
90–
than what is prescribed above, then the entry or exit shall be provided at the farthest end of the plot from the intersection.
11.7. No barbed wire fence or cactus hedge shall be permitted along the boundaries abutting on a public road.
11.8. A sheet metal fence along the boundaries of a plot abutting a street or streets shall not be erected until the design thereof has been approved by the Licensing Authority.
11.9. No compound wall shall obstruct the right of way of the roads as prescribed in the designated plan/map and shall not block the traditional access passing through the property.
191[11.10. In case of industrial estates/industrial areas, the compound height shall be maximum 3.00 mts. With maximum construction height upto 2.00 mts. And barbed wire or chain linked for remaining 1.00 mt. subject to clearing of line of sight.]
- Sub-division regulations.—
The sub-division of land shall conform to the provisions given below regarding roads, surface and storm water drainage, sloping sites, open spaces, size of plots and their frontage and means of access.
These regulations shall be applicable to new sub-divisions in all zones 192[( , except in zones A1 & A2)], which shall be governed under ‗Other Regulations‘ at 193[12.7].
Provided that sub-division regulations regarding minimum size of plot, Frontage etc. shall not apply to the original plots having independent surveys No./chalta No. for the purpose of permitting any development within the plot in terms of zoning and land use provisions. Also appropriate provisions shall be made for garbage, sewerage, water supply, electric supply, telephone lines, cable television, etc. and other essential services as required in the Regulations.