3.1.3.1 Internal Roads in layouts for residential and non-residential land use
In the development of layouts, the requirements of internal roads shall be done as follows:
| Min. road width (m) - Built-up area | Min. road width (m) - Non-built-up area | Length of internal roads in layouts for residential use (m) | Length of internal roads in layouts for non-residential use (m) |
|---|---|---|---|
| 4 | 7.5 | Up to 150 | - |
| 6 | 9 | >150 to 300 | Up to 150 |
| 7.5 | 12 | >300 to 600 | >150 to 300 |
| 9 | 15 | >600 to 900 | >300 to 600 |
| 9 | 18 | >900 to 1200 | >600 to 1200 |
| 9 | 24 | >1200 to 1500 | >1200 to 1500 |
| 9 | 30 | >1500 | >1500 |
Note:
(i) The minimum width of 'Loop Street' shall be 7.5 meters and maximum length shall be 300 meters. For ‘Loop Streets’ of length up to 600 meters, the minimum width shall be 9 meters.
(ii) The minimum width of the road adjacent to the park/open space and the roads with abutting plots proposed only on one side shall be 6.0 meters up to 150-meter length and shall be 7.5 meters up to 300-meter length.
(iii) In a 9 m-wide-road which is straight and closed at one end (dead-end street), adequate area with minimum semi-diameter of 7.5 meters shall be provided for the node and the maximum length of such road shall be 100 meters. But cul-de-sac shall not be required in dead-end streets up to 25 meters long.
(iv) In case of EWS/LIG housing schemes, the internal roads (motorable) shall be a minimum 6- meter-wide. The maximum length of a 3-meter-wide road shall be 50 meters and the maximum length of a 4.5-meter-wide road shall be 80 meters. No residential unit shall be located farther than 150 meters from a 9-meter-wide access road.
(v) The width of other roads shall be as prescribed in the master plan/zonal plan.
3.1.3.2 Intersection of roads
(i) As far as possible, the roads shall be joined at right angles and the alignment of the center lines of all the roads at the junction shall be in a straight line.
(ii) Proposed roads at an angle of less than 30 degrees shall be permitted only when proper arrangement for traffic movement is ensured and the required weaving length is available.
(iii) Road junctions shall be as per Indian Road Congress /other applicable standards.
(iv) The minimum distance between two T-junctions on roads less than 18 meters wide shall be two and a half times the width of the wider road meeting at the junction.
(v) The minimum distance between two junctions on roads wider than 18 meters shall be as follows:
(vi) 150 meters for roads of width 18 to 24 meters,
(vii) 300 meters for roads wider than 24 meters.
3.1.3.3 Calculation of road length
The length of the road shall be calculated from the meeting point of the road which is wider than that road.
3.1.3.4 Block length
In plot development, the maximum length of the block shall be 300 meters.
3.1.3.5 Drainage system
For drainage system, drains shall be an integral part of the road and they shall have sufficient slope so that water can drain automatically.
3.1.3.6 Other requirements
The road margins shall be kept as unpaved as possible, or provision of pathways shall be made. Such pathways shall be made of perforated material or provision of ‘brick-on-edge’/ ‘loosestone pavement’ shall be made, to ensure maximum groundwater recharge.
3.1.3.7 Specifications/provisions of cycle track construction
In the layout of the schemes, provision for cycle tracks may be made on roads 18.0 meters wide and above to promote usage of sustainable modes of transport such as bicycles. The specifications/provisions of cycle track construction shall be as per IRC code (IRC-11-1962) as amended from time to time.