1. Introduction: Communication System
Data growth is exploding globally and in India as per Nokia MBiT 2021 Report, the average monthly data usage per user in India has increased almost 17 times over the past 5 years. Covid 19 has further pushed data consumption with people staying indoors. Government has facilitated Work from Home (WFH) guidelines with a Work from Anywhere (within India) permitted. Home consumption of data has therefore grown exponentially through 2020. According to the Tower and Infrastructure Providers Association, almost 85% data traffic and 70% voice traffic is now generated indoors.
The World Bank has clearly demonstrated that every 10% increase in broadband penetration leads to nearly 1.40% increase in GDP growth rate. While that is a global average, even the India specific study by the reputed quasi-Government research agency, ICRIER, has shown that every 10% increase in internet traffic delivers 3.1% increase in GDP per capita and a 10% increase in investment in Telecom Infrastructure will increase GDP by 3.3% The entire consumer pull today is focused on data and broadband now with the new digital services providing voice services free with the data services. Video and app-based services are driving the demand for broadband with Apps for e-commerce,
e-healthcare etc. in everyday use. It is very clear that internet traffic and Apps are contributing to GDP growth and for this to grow even further, conventional connectivity needs to be replaced with duct-sharing and fibre especially, which is an essential requirement In-Building as much as it is for FTTx and Tower Fibreization.
{Note - “Service Provider”: an agency that provides any type of telecom / IT services in a building complex, as per scope defined by DOT i.e. TSP / ISP / IP1 etc.}
A broad variety of Information Communication Technology (ICT) systems are expected to be installed in buildings. In order to facilitate proper cabling and installation /up gradation of ICT systems and their cost effectiveness and maintenance, adequate physical infrastructure is required within buildings. This infrastructure will include common ducts, cable riser systems, conduits, cable trays and utility closets etc. among other things. The same can also be retrofitted into existing buildings wherever possible and feasible and must be designed in all new, re-developed and renovated structures. This section describes the general and specific requirements of such an ICT infrastructure in Building specially in respect of cabling aspects.
Communication systems are general utility in much the same way as water, power, gas, cable TV & CCTV/Security. Unlike traditional communication systems which are constantly evolving, the recommended Digital infrastructure has to be designed to be flexible enough to accommodate a variety of ICT systems and emerging technologies and be future proof for the next 25-30 years. Space and power is required for installation of common ducts, optical fibre, small cells, antennas, smart sensors etc, space, power and earthing is required for electronic equipment installation for supporting the various digital technologies of now and the future. Most communication utilities can share the same space since the physical topology and wiring requirements are similar and no significant power is present in the cables. However, in some cases state-of-the – art communication cabling or equipment will involve new or more specific requirements for utility spaces such as:
Cable routing layout and cable length restrictions between Work-Space and utility closet.
Bending radius and working clearance requirements for different cable types, e.g. Fibreoptic cables, Cat-6 Cables and co-axial cables
Isolated power circuits for permanent communication equipment,
Protection, Safety, Grounding and environmental requirements of communication equipment.
2. Emerging Technologies in Telecommunication Services
The technologies used for telecommunications have changed greatly and over the past few years and particularly during the pandemic, India has experienced a massive surge in indoor voice and data consumption. According to the Tower and Infrastructure Providers Association, almost 85% data traffic and 70% voice traffic is now generated indoors. Telecommunication network architecture is changing to meet new requirements for a number of services/applications viz. 5G, massive Internet of things, Artificial Intelligence etc.
Choosing efficient and cost-effective and fast-deployment technologies such as wired and wireless networks will improve accessibility. Based on type of building and profile of customers in the buildings, the needs of wired and wireless may vary. Further, the architecture of the information and communication infrastructure is changing to accommodate the requirements of a growing number of ICT-enabled services/applications (broadband, IP, mobile, multimedia, surveillance, IoT etc.)
In line with the changing market needs, the Digital Service Providers (TSPs)/ISPs/IP-1’shave been scaling up the deployment of in-building solutions (IBS) and FTTx, covering active and/or passive infrastructure. Further, industry stakeholders are putting greater emphasis on sharing in-
building infrastructure to save capex and capex, as well as to avoid the duplication of infrastructure deployment.
Moving forward, the humungous growth of data traffic riding on the use of the digital infrastructure during the pandemic and with the new WFH (Work-from-Home) and work-fromanywhere paradigms and with the emergence of 5G are expected to create huge opportunities for extension of ubiquitous, reliable and high-speed digital infrastructure into the homes and inside residential buildings, and lead to huge growth of shared in-Building Solutions sites.
Theoretically, wireless services can be provided from outside the building. However, there are appreciable losses in signal strength when it penetrates building walls. While all wireless services can suffer from poor in-building coverage, this problem is particularly pronounced for the highspeed services. These services require a much better signal quality than their voice counterpart. Therefore, in order to improve in-building coverage and to offer better-quality high-speed data services, there is a definite need to install in- building solutions (IBS) for augmenting the wirelessbased voice and data services. This is equally true for installing 5G and Wi-Fi hotspots along with Fibre to x(FTTX) distribution network of Fiber and Cat-6 Cables for seamless data connectivity.
Provisioning of telecom services and broadcasting services viz. Cable TV, DTH and Security Services viz. CCTV Cameras and futuristic services viz. IoT based sensors would require suitable wireline connectivity inside the buildings inside buildings are not confined to wireless medium only. Wireline services through cables such as copper cables, optical fibre cables (OFC), LAN Cat-6 cables are also equally important for having uninterrupted connectivity. Also, for services such as Cable TV, DTH and Smart Devices Solutions (IoT), suitable cabling within building premises is a pre- requisite and for that, shared duct space across the building riser and floors is critical to achieve the flexibility in the future.
3. Policy Efforts
The proliferation of in-building connectivity has become a key component of government policies. The National Digital Communications Policy, 2018 proposes to make the installation of telecom infrastructure and associated cabling and in-building solutions mandatory in all commercial, residential and official buildings (including government buildings) by amending the National Building Code of India with the help of the Bureau of Indian Standards.
The Government has been taking a number of steps for promoting the sharing of in-building infrastructure, in line with TRAI recommendations.
a) In October 2019, the Digital Communications Commission (DCC) approved in-building access and sharing of infrastructure among TSPs, thereby allowing them to share infrastructure and, in the process, curbing TSPs’ monopoly to install infrastructure through exclusive contracts with the owners/builders.
b) In November 2019, the Department of Telecommunications issued an advisory to encourage all TSPs/IP-1s to share their in-building infrastructure such as systems, optical fibre, other cables, ducts and boosters on government premises and other public places such as airports, railway stations, bus terminals and hospitals.
The government’s policy and regulatory push coupled with the ever-expanding data usage has propelled TSPs/IP-1s to scale up the deployment of IBS. There is an urgent requirement to allow TSPs/IP-1s to own active built and manage active infrastructure in addition to passive infrastructure to help them cater to the ever-increasing data demand.
Bureau of Indian Standards (BIS) has framed National Building Code of India under which provision of Common Telecom Infrastructure (CTI) housed inside the buildings for convenient provision of telecom services has been envisaged.
Making cities smarter: Ministry of Housing and Urban Affairs led Smart Cities Mission is another key driver that is encouraging the adoption of in-building solutions (IBS) and FTTx/ IP networks covering Fiber and LAN cables. Since, the success of the mission relies on the underlying digital communications infrastructure, the cities identified under this programme have mandated to install common infrastructure inside buildings to enable seamless connectivity. To this end, certain smart cities have started collaborating with infrastructure providers to scale up the deployment of IBS and Fiber network. Moving forward, IBS and FTTx/ IP networks covering Fiber and LAN cables should be included as one of the key parameters in the selection of smart cities for granting financial assistance.
4. In- Building and Gated Buildings Solutions
It is important to ensure quality telecom services inside a building – in residential, multi-story building, commercial complex, hotel or airport, police/Government offices/buildings etc. It is also essential for Telecommunication Service Providers/IP-1s to work on sharing of telecom infrastructure which may be made mandatory as they extend the services in the buildings.
Telecom Service Providers/IP-1s require a non-discriminatory and unhindered access inside the building / along the premises to install the telecom infrastructure or lay their cables.
At present, mobile operators and the building owner or building developer or Resident Welfare Associations (RWA) enter into commercial agreements for inbuilding deployment. Building owners or building developers delay the negotiations or request exorbitant rents — slowing down the speed of deployment. The Urban Local Body /Urban Development Authority may intervene in this regard wherein commercial agreements are insisted upon. TSPs/IP-1s should be given legal rights and permissions to use the Common Telecom Infrastructure (CTI) within the premises of Building / Gated Society free of charge or for a standardized nominal charge just like other essential services like water electricity and/or gas. Provision of CTI in a building should not be deemed as a revenue source in any way, much as the water and electricity utilities are not. Sufficient space should be provided within the premises to install telecom services by MNOs/ network operators.
The issue is not limited to sharing of IBS/ Distributed Antenna System (DAS) systems only, but TSP should get access to all telecom infrastructures including Fiber Cable and LAN cables for provision of wired and wireless network, other telecom/ ICT and IoT services.
It is important for telecom service providers to provide mobile coverage / network presence/high speed connectivity inside big residential / commercial complexes to improve QoS of their networks. It may not be practical to install individual in-building infrastructure by TSPs/IP-1s as this will result in not only duplication of network resources but will also entail huge avoidable cost. It may also be not advisable to lay down cables again and again on the same land / building by several TSPs/IP-1s.
5. Incorporation in State /UT Building Bye Laws
The buildings are to be constructed in such a way that they are ‘Digital Infrastructure deployment’ / ‘Digital Connectivity’ ready. There should be provision of telecom ducts / common pathways / runways (digital access paths) to reach to the accessible parts of the buildings. The common ducts /digital access paths to access buildings from outside should invariably be part of the CTI, which could be used by TSPs/IP-1s for laying/deploying digital infrastructure including cables.
While approving the building plans, it has to be ensured that plan for creation of CTI including the common duct to access the common space used as telecom room inside the building is also prepared and separate set of drawings showing the inter / intra connectivity access to the building with distribution network need to be furnished.
Occupancy-cum-Completion certificate to a building to be granted only after ensuring that the CTI as per the prescribed standards is in place and an undertaking by the Architect or Engineer to be insisted to certify that building has ensured common access to all digital infrastructure to all Service providers in accordance with plan of creation of CTI. Provision of visit from Department of Telecom (DoT) / TRAI officials along-with joint inspection with TSPs - who may suggest any relevant modification in the plan to be ensured.
As part of Building Bye-Laws, the builder/RWA should be mandated to ensure that
-
While preparing the building plans, there is a need to mandate to have properly demarcated sections within buildings and on rooftops for housing Broadband / digital connectivity infrastructure / antenna. These areas should have access to power supply for reliable, always-on services.
-
Access to building as well as CTI facilities inside the building should be available on a fair, transparent and non- discriminatory manner to all Service Providers /IP1’s.
-
The Service Providers / IP1’s should have unrestricted access for maintenance work.
-
The permission to in-building access and/or CTI facilities inside the building should not be seen as a source of revenue generation for builder(s)/RWA(s) but as a means for facilitating penetration of broadband access and thereby helping in socio-economic growth of all the residents.
-
Charges (rentals/power rates etc.) levied to the TSPs/IP-1s should be fair, transparent and non-discriminatory and should be on residential rates.
Suitable provision for the creation of Common Telecom Infrastructure (CTI) inside the newly constructed public places like Airports, commercial complexes and residential complexes, be incorporated in State/UT Building Bye Laws.