General.—Brake shall be provided in all lift machines to prevent the rotation of the lift motor and thus preventing any drive to the lift car when there is no power supply to the lift motor.
(ii) Operation.- The brakes provided in the lift machines shall be of mechanically operated type, which are released by an electromagnet or an electrical motor.
(iii) Material .- All materials used shall conform to the relevant Indian Standards.
(iv) Requirements.—(a) there shall be no friction drive interposed between the brake drum and the traction sheave.
(b) The brake shall be capable of sustaining a static load equivalent to 125 percent of the rated load in the lift car, that is, it should be capable of preventing the lift car from movement with a load of 125 percent of the rated load, with the lift car at rest.
(c) No toggle mechanism shall be used in the operation of the brake.
(d) When spring/springs are used to apply the brake, they shall be of the compression type and shall be adequately guided and supported.
(e) The brake lining used shall be of fire-proof material and shall be so secured to the shoes that their normal wear shall not weaken their fixings. They shall conform to IS-2742.
(f) The brake shall not be released under any circumstances unless electric power is applied to the lift motor. Any electrical fault in the electrical brake circuit shall not prevent the brake from being applied when power supply to the lift motor is interrupted.
(g) A continuous flow of current is required to held off the brake when the lift is in normal use.
(h) The interruption of this current shall be effected by at least two independent electrical devices, whether or not integral with those which cause interruption of the current feeding the lift machine.
If, when the lift is stationary, one of the contractors has not opened the main contracts, further movement shall be prevented, at the latest at the next change in the direction of motion.
(i) Braking shall become effective without supplementary delay after opening of the breaker release circuit (The use of a diode or a capacitor connected directly to the terminals of the brake coil is not considered as a means of delay).
(j) Provision shall be made for releasing the brake manually in case of emergency. “As soon as the hand pressure is released brake should be applied immediately.
(2) Band brakes are forbidden.