(1) Division of plot into smaller units is permissible in core areas with the prior approval of the Competent Authority. Each such plot shall be accessible separately and independently through a public road laid out and constructed to the satisfaction of the Competent Authority.
(2) 18[Except as otherwise expressly provided at the time of sale of a plot, not more than one building unit shall be erected on any one plot, but two or more plots may be amalgamated for purpose of erection of one “building unit”. In case of back to back plots which are to be amalgamated, two building units may be allowed maintaining the rear setbacks intact subject to the condition that a maximum of four dwelling units shall be permissible on the amalgamated plot.
Note:- “Building unit” means a self-contained building with such out buildings as are ordinarily ancillary to the main
18 Final amended substituted vide Misc-2339-(ULB)-VOL-II/7/5/2006-2TCP dated 06.11.2020.
[38]
building used in connection therewith and physically incapable of sub-division into two or more independent building units. A building unit may, however, be owned by an individual/ firm/ company or may be jointly and severally owned, provided it remains in a single indivisible ownership.]
(3) The Competent Authority shall be competent to refuse permission for construction on consideration of compact and economical development of the area till such time as availability of water supply, drainage arrangement, and other facilities are ensured to his satisfaction.
(4) In case plots which are to be amalgamated are back to back, then rear setback shall be maintained as per already approved zoning plan.
(5) In case plots adjacent plots are to be amalgamated, then setbacks shall be maintained as per zoning plan approved by the Competent Authority for whole amalgamated plot.
(6) Amalgamation of adjacent plots (side by side or back to back or both) where building stand constructed is permitted, subject to the condition that the constructed buildings shall not violate the provisions of zoning plan issued by the competent authority for the amalgamated plot.
(7) 19[The plots once amalgamated (either adjacent or back to back) may be allowed to be de-amalgamated subject to the condition that constructed buildings on these de-amalgamated plots shall conform to the approved zoning regulations of individual plots.]
6.3. Proportion of the site which may be covered with buildings.
(1) The proportions of covered area of a building, including ancillary buildings, shall be in accordance with the plot categories given in following sub-Codes and the remaining portion shall be left open in the form of open space around the building.
(2) Core Areas
(i) 20[Residential
| Sr. no. | Plot area slabs | Maximum permissible Ground Coverage | Permissible basement | Maximum permissible Floor Area Ratio (FAR) | Maximum permissible Height (G+3 Floor) (including stilt (S+4 Floor)) |
|---|
19 Final amended substituted vide Misc-2339-(ULB)-VOL-II/7/5/2006-2TCP dated 06.11.2020. 20 Inserted/amended by Misc-2339(ULB)-Vol-III/SD(DK)/2019/7/19/2019-2TCP dated 04.06.2019 and further amended on Misc-2339-VOL-III-ULB/7/5/2006-2TCP dated 20.10.2020.
[39]
| (in metres) | |||||
|---|---|---|---|---|---|
| 1 | Upto 60 square metres | 85% | Single level | 220 % | 16.5 |
| 2 | Above 60 to 150 square metres | 80% | Single level | 200 % | 16.5 |
| 3 | Above 150 to 225 square metres | 70% | Single level | 180% | 16.5 |
| 4 | Above 225 to 450 square metres | 60% | Single level | 160 % | 16.5 |
| 5 | Above 450 square metres | 50% | Single level | 140 % | 16.5] |
(ii) Commercial
| Sr. no. | Plot area slabs | Maximum permissible Ground Coverage | Permissible basement | Maximum permissible Floor Area Ratio (FAR) | Maximum permissible Height |
|---|---|---|---|---|---|
| 1 | upto 50 square metres | 100% | Single level | 200 % | Unrestricted |
| 2 | Above 50 to 150 square metres | 85% | Single level | 200 % | Unrestricted |
| 3 | Above 150 to 225 square metres | 75 % | Single level | 200 % | Unrestricted |
| 4 | Above 225 to 450 square metres | 60 % | Single level | 175 % | Unrestricted |
| 5 | Above 450 to 1000 square metres | 40% | Single level | 175 % | Unrestricted |
Note: Example for calculating FAR and ground coverage as per plot area slabs for 14 marla and 1 Kanal plot:
| Calculations for Ground Coverage | ||||
| Plot area slabs | Area in each slab (in square metres) | Maximum permissible Ground Coverage | 14 marla plot (354.1 square metres) | 1 Kanal plot(505.86square metres) |
| Upto 75 | 75 | 66 | 49.5 | 49.5 |
| 76-100 | 24 | 66 | 15.84 | 15.84 |
| 101-150 | 49 | 60 | 29.4 | 29.4 |
| 151-250 | 99 | 60 | 59.4 | 59.4 |
| 251-350 | 99 | 50 | 49.5 | 49.5 |
| 351-500 | 149 | 50 | 4.05 | 74.5 |
[40]
| 501-1000 | 499 | 45 | 4.8861 | |
| 207.69 | 283.0261 | |||
| Actual permissible ground coverage | 58.6529229 | |||
| Calcul | ations for Floor Area R | atio (FAR) | ||
|---|---|---|---|---|
| Plot | Area in each | 1 | ||
| area | slab (in square | Maximum | Kanal(505. | |
| slabs | metres) | permissible Floor Area Ratio (FAR) | 14 marla(354.1 square metres) | 86 square metres) |
| Upto 75 | 75 | 165 | 123.75 | 123.75 |
| 76-100 | 24 | 165 | 39.6 | 39.6 |
| 101-150 | 49 | 145 | 71.05 | 71.05 |
| 151-250 | 99 | 145 | 143.55 | 143.55 |
| 251-350 | 99 | 125 | 123.75 | 123.75 |
| 351-500 | 149 | 120 | 9.72 | 178.8 |
| 501-1000 | 499 | 100Actual permissible FAR | 511.42144.4281276 | 10.858691.358136.6703699 |
(iii) Plot setbacks (core areas)
The buildings shall not project beyond the building lines as shown in the zoning plan of respective schemes. However, in case where zoning plans are not prepared, the minimum setbacks shall be provided as below:-
| Sr. No. | Area of plot (in square metres) | Minimum Front Setback (in metres) | Minimum Rear Setback (in metres) |
|---|---|---|---|
| 1. | Upto 60 square metres | 0.5 | 0.5 |
| 2. | Above 60 to 150 square metres | 1.5 | 1.0 |
| 3. | Above 150 to 225 square metres | 2.5 | 2.0 |
| 4. | Above 225 to 450 square metres | 3.0 | 3.0 |
[41]
| 5. | Above 450 square metres | 4.5 | 4.0 |
|---|
(a) The front setbacks can be adjusted to achieve permissible Ground Coverage subject to the condition that rear setbacks are fixed.
(b) In core areas single level basement may be allowedupto the maximum roof height of not more than 1.5 metres from the ground level for the area of maximum permissible coverage and after that till the zoned area, the roof of basement shall flush with the ground level.