The trip distribution model estimates number of trips travelled from one zone to another. Trip generation only finds the number of trips that begin or end at a particular zone. The process of trip distribution links the trip ends to form an origin-destination pattern. Trip distribution is used to represent the process of destination choice (i.e. "I need to go shopping, but where should I go to meet my shopping needs?").
The most commonly used procedure for trip distribution is called the gravity model. The gravity model takes the trips produced at one zone and distributes to other zones based on both the size of the other zones (as measured by their trip attractions) and the composite cost (travel time, distance or cost for all modes available) to other zones. A zone with many trip attractions (say, a large shopping center) will
receive a greater number of distributed trips than one with few attractions (a small shopping center). The mathematical formula for a gravity model is shown below:
Where,
T j . ~ the number of trips from zone i to zone j ,
P i = the number of trip productions in zone
A j = the number of trip attractions in zone j,
F i j = the friction factor relating the spatial separation between zone i and zone j, and
K i j = an optional trip-distribution adjustment factor for interchanges between zone i and zone j.
Distance to possible destinations is the other factor used in the gravity model. The number of trips to a given destination decreases as the distance to the destination increases (it is inversely proportional). This is represented in a factor called friction factor. It is inversely proportional to the distance or travel time between two zones. Friction factors are used to calibrate trip lengths from the model to observed data. The most common formulation of friction factors is through a gamma function as shown below:
Where,
F Y = the friction factor between zones i and j,
a, b, and c = model coefficients; both b and c should, in most cases, be negative; a is a scaling factor and can be varied without changing the distribution,
t i = the travel time between zones i and j, and
e = the base of the natural logarithms.
Validation and Reasonableness Checking for trip distribution
Compare trip length frequency from model and survey data.
Do this for every purpose
Do this for distance and time
If different, adjust friction factors in the model
Maximum of 5-10% difference in observed and modelled.
Compare trip patterns from the model to data from O-D Surveys.
Aggregate data into districts and compare trips
Look at north-south and east-west trips