Affordable Housing Overlay Rules.— (1) With a vision to ensure access to formal housing for all sections of society living in Development Area, following development control norms (affordable housing overlay) are prescribed for facilitating development of EWS or LIG or MIG housing units.
The category-wise, size of the dwelling units shall be as given in Table No.19 below:
| Table No. 19: Category wise size of dwelling units | ||
| Sl. No. | Category of Dwelling Units | Size of the Dwelling Units (in square meters of carpet area) |
| (a) | (b) | (c) |
| 1 | Economical Weaker Section (EWS) | Up to 30 square meters |
| 2 | Low Income Group (LIG) | Up to 60 square meters |
| 3 | Middle Income Group -I (MIG-I) | Up to 160 square meters |
| 4 | Middle Income Group -II (MIG-II) | Up to 200 square meters |
| Note: The size of the dwelling units shall be modified, if the sizes are varied in the "Policy for Housing for all in Urban Areas, 2015", as amended from time to time. | ||
Maximum density for EWS and LIG Housing projects shall not exceed beyond the limits as specified in Table No.20 below:
| Table No.20: Maximum Density specification for EWS and LIG housing | ||
| Sl. No. | Plot Area (in square meters) | Maximum Density (Dwelling Unit/ Acre) |
| (a) | (b) | (c) |
| 1 | Up to 4000 square meters | 300 dwelling units per acre |
| 2 | From 4000 square meters to 10000 square meters | 250 dwelling units per acre |
| 3 | Plots more than 10000 square meters | 200 dwelling units per acre |
The following relaxations in development control regulations and building norms shall be applicable to the extent of Economically Weaker Section (EWS) and Low Income
Group (LIG) housing in apartment building and housing projects, namely:—
(i) The distance between two building blocks shall be a minimum of 2 meters.
(ii) Parking requirements for Affordable Housing Projects can be accommodated within setback areas, between building blocks or open areas subject to condition that at least 1.2 meter driveway for one side parking and 1.5 meter driveway for both side parking, shall be provided.
(iii) The side setbacks may vary depending upon the plot size and plan prepared for a particular project, subject to provision of at least 1 meter side setback on either side. The sum total of both side setbacks in a particular project shall comply with these rules.
(iv) The DP&BP committee may relax the requirement of minimum RoW of the means of access to not less than 6 meters for non-high rise apartment building.
(v) One staircase for every 12 dwelling units or fraction thereof in a floor shall be provided.
For the purpose of ensuring provisions of Housing for all, the State Government has notified a policy that is “Policy for Housing for All in Urban Areas, Odisha- 2015” which prescribes mandatory development of EWS housing, incentives to be given to private developer and Government agencies in terms of FAR, norms for promotion of mixed use development and relaxations in terms of various fees and charges.
The “Policy for Housing for All in Urban Areas, Odisha- 2015”, as amended from time to time, shall be applicable to building plan approval of all such projects:
Provided that incentives and provisions prescribed in this policy for promotion of affordable housing are model specific that is to say, a provision under one model cannot be made applicable to projects taken up under another model.
To ensure development of MIG housing, following incentives shall be provided, namely:—
(i) in apartments and housing projects, for the dwelling units under MIG category, parking requirements shall be calculated at minimum of 25% of total built-up area of such dwelling units;
(ii) the developer shall be entitled to receive additional FAR equivalent to 20% of the built-up area utilized for MIG units and the said additional FAR can only be utilized in the same project subject to a maximum additional FAR of 0.25.
External infrastructure that is development of road connectivity as per plan, street lighting, water supply, sewerage connection, solid waste management facility and public transport services to the battery limits of projects taken up under Model- 3, 4 and 5 of the Policy for Housing for All in Urban Areas, Odisha— 2015 shall be provided by concerned Government agencies without any infrastructure or development charges to the projects.
In case of Slum Improvement and EWS housing, the building parameters shall be applicable as per “Policy for Housing for all in Urban Areas, 2015”, as amended from time to time.
Transit Oriented Zone (TOZ) Overlay Rules.— (1) This Overlay Zone provides opportunity for mixed use and higher density development along the notified transit priority corridors to encourage and promote compact mixed use development in this zone and TOZ shall help in sustainable urban development by ensuring that maximum number of people can live, work or find means of recreation within walking or cycling distance of the transit priority corridors.
The transit priority corridors, extent of the TOZ along such corridors and applicability of development control norms in such TOZ shall be notified by Authority, from time to time and the same shall be defined as per the following overall framework, namely:
(i) up to maximum of 400 meters wide belt on both sides of centre line of the notified transit priority corridors can be TOZ;
(ii) in case a part of plot or project site falls within notified TOZ, then the whole plot or project site shall be included in TOZ;
(iii) development control norms overlay shall be within the overall framework of sub-rule (4).
TOZ overlay will override general provisions of development control regulations to the extent provided herein but the same shall not override the provisions related to following:
(i) Environmentally Sensitive Zone;
(ii) Special Heritage Zone;
(iii) Open Space Use Zone;
(iv) Agricultural and Forest Use Zone;
(v) Water Bodies Use Zone;
(vi) any other use zones in which higher intensity of development allowed under TOZ is not desirable, as decided by Authority, from time to time.
The following Development Control Norms shall be applicable in TOZ Overlay, namely;—
(i) The TOZ shall allow flexibility in provision of a mix of various uses within the same plot, with the exception of the following polluting and potentially hazardous uses affecting security, safety and environmental quality, of such areas,
(a) Retail shops - building materials, timber, building products, marble, iron, steel and sand, firewood, coal,
(b) Repair shops - automobile repair and workshops, cycle rickshaw repairs, tyre resorting and retreading, battery charging,
(c) Service shops - flour mills, (more than 3 KW power load), fabrication and welding,
(d) Storage, godown and warehousing,
(e) Manufacturing units (excluding household industry),
(f) Junk shop,
(g) Other hazardous, polluting and nuisance causing uses,
(h) any other use which in view of Authority is analogous to entries listed above;
(ii) maximum permissible FAR shall be allowed in TOZ as prescribed under rule 35;
(iii) mixed use of the plot or project site and/or building shall be permitted in TOZ subject to following conditions, namely:—
(a) principal use shall cover not less than 50% (fifty percent) of total built-up area and rest of the built-up area may cover any one or more of the permissible uses;
(b) for the purpose of this rule, principal use may be any of the permissible uses as allowed under clause (i);
(iv) The front setbacks on some or a part of the Transit Priority Corridors, having character of commercial streets, shall have fixed frontal setbacks as provided in Table No.21. The extent of such streets shall also form the part of the notification of Transit Priority Corridor notified by the Authority under subrule (2);
(v) The fixed frontal setback is required to achieve a continuous building facade along a street edge to form a build-to line and it is further provided that all buildings shall be required to coincide with this line up to a minimum of 50% (fifty percent) of this line; and
| Table No. 21: Fixed frontal setback for Buildings | ||
| Sl No. | Front Setback (in meters) | Width of Street Fronting the Plot (in meters) |
| (a) | (b) | (c) |
| 1 | 1.5 | Up to 9.0 |
| 2 | 3.0 | Above 9.0 and up to 18 |
| 3 | 4.5 | Above 18 and up to 30 |
| 4 | 4.5 | Above 30 |
Note.— The Authority may modify the norms prescribed in the Table as per character prevailing in their development area concerning to TOZ.
(vi) In the plots/ project sites for which provisions of 10% (ten percent) EWS housing are mandatory as per affordable housing overlay, additional provisions shall be made for reservation of 10% (ten percent) of built-up residential space for LIG or MIG housing and for such reservations, incentives allowed under affordable housing overlay shall be available;
(vii) All apartment building, housing projects, commercial, public buildings, mixed-use buildings shall not have any boundary wall and the entire setback area shall be considered as Public Open Space (POS):
Provided that provision of plantation, underground rainwater harvesting structure, ground water recharging pits, electric-substation and public
washroom complex shall be permitted in such setback area and the Authority may prescribe guidelines for siting of abovementioned provisions within such public open spaces:
Provided further that in case of high-rise buildings the setback around the building for a width of 7.5 meters shall be kept unbuilt and free from obstruction except where the open space requirement is less than 7.5 meters, the entire specified open space shall be kept unbuilt and it shall be constructed of hard surface capable of taking load of fire engine weighing up to 45 tonnes;
(viii) Provision of a minimum 10% (ten percent) of additional Public Open Space (POS) shall be mandatory in all developments over plot size of more than 2000 square meters. This shall be subject to the following conditions, namely:—
(a) This Public Open Space shall be open to all and shall provide facilities like badminton court, tennis courts, basketball courts, bus stops, toilets;
(b) Public amenities provided in POS as part of the development shall be exempted from calculation of FAR;
(c) The Authority may prescribe guidelines for effective utilization of such public open spaces;
(ix) For plot size more than 1 Acre, Through-Block Linkages of width not less than 3.0 meters shall be provided to improve connectivity and to encourage walkability within the TOZ; and
(x) The area under Setbacks, Public Open Space and Through Block Linkage shall be surrendered to the Authority without any cost and the authority, in lieu of such surrendered land shall provide TDR certificate to the applicant as prescribed under sub-rule (4) of rule 36.
Mixed-Use Zone Overlay Rules.— (1) This Overlay Zone provides opportunity for development of a diversified and pedestrian oriented urban environment where a mix of uses are encouraged, by allowing greater flexibility in development and to promote walk-to-work environment.
Mixed Use Overlay shall be applicable only on streets with width of 18 meters or more, as notified by Development Authority after due consultation with all stakeholders and subject to all such norms, terms and conditions including charges, if any, as are prescribed in such notification.
Mixed use Zone overlay shall override general provisions of development control regulations to the extent provided herein but same shall not override provisions of other following overlays or land uses, namely:—
(i) Environmentally Sensitive Zone;
(ii) Special Heritage Zone;
(iii) Open Space Use Zone;
(iv) Agricultural and Forest Use Zone;
(v) Water Bodies Use Zone;
(vi) Transit Orientated Zone;
(vii) any other use zones in which mixed use development under this overlay is not desirable, as decided by Authority from time to time.
The following Development Control Norms shall be applicable in Mixed use Overlay, namely;—
(i) The Mixed Use Overlay Zone shall allow flexibility in provision of a mix of various uses within the same plot, with the exception of the following polluting and potentially hazardous uses affecting security, safety and environmental quality, of such areas,—
(a) Retail shops - building materials, timber, building products, marble, iron, steel and sand, firewood, coal,
(b) Repair shops - automobile repair and workshops, cycle rickshaw repairs, tyre resorting and retreading, battery charging,
(c) Service shops - flour mills, (more than 3 KW power load), fabrication and welding,
(d) Storage, godown and warehousing,
(e) Manufacturing units (excluding household industry),
(f) Junk shop,
(g) Other hazardous, polluting and nuisance causing uses,
(h) any other use which in view of Authority is analogous to entries listed above;
(ii) The FAR utilization and mix of uses within various permissible uses shall be as per following conditions, namely:—
(a) principal use shall cover not less than 50% (fifty percent) and not more than 75% (seventy five percent) of total built-up area and rest of the built-up area may cover any one or more of the permissible uses and it is further provided that for the purpose of this rule, principal use may be any of the permissible uses as allowed under clause (i); and
(b) on the ground floor facing the main street, there shall be provision for retail or/and commercial use only and it is further provided that there shall be fixed frontal setbacks as provided in clause (v) of sub-rule (4) of rule 75, under TOZ overlay.
(c) Maximum FAR shall be allowed as per the provisions prescribed under rule 35.